Leather Bally Flexing Tester  HZ-3001
Leather Bally Flexing Tester  HZ-3001
Leather Bally Flexing Tester  HZ-3001

Leather Bally Flexing Tester HZ-3001

Leather Bally Flexing tester is used to test the folding nature for various leather and fabric.The machine used to test the folding nature for various leather and fabric, Materials need be nipped both inside and outside, Twist and turn over and over again until a certain number, Observe the damage of the tested materials, this machine applied to use in clothing, shoes, bags and other thin material leather.
Contact number: +86 136 6988 3531

Contact Us Download VR

Equipment Summary

Leather Bally Flexing tester is used to test the folding nature for various leather and fabric.The machine used to test the folding nature for various leather and fabric, Materials need be nipped both inside and outside, Twist and turn over and over again until a certain number, Observe the damage of the tested materials, this machine applied to use in clothing, shoes, bags and other thin material leather.

Corresponding Standard
According to the standard BS-3144,JIB-K6545

Applicable Industry
Used to test leather performance in shoes, clothing, luggage handbag industry, research laboratories; commodity inspection, arbitration and technical supervision departments.

Technical Parameters

 Model  HZ-3001 Leather bally flex tester
 Fixture  12 group sets
 Specimen size  70 x 45mm
 Reverse angle  22.5 degrees
 Counter  LCD from 0 to 999,999
 volume  about 78 * 46 * 32cm
 Machine Weight  78kg 

Machine Structure





 
1. Power switch 2. Test switch
3. Counter 4. Upper grip
5. Lower grip 6. Base


Specimen Installation Method
  • The specimen surface folded inward, its one end fixed on the upper fixture
  • Jig into upper levels (start inching switch adjustment knob, turned on the fixture of the axis of rotation Angle curve ring indicator at 0 score).
  • Specimens with another free side as the outer surface of specimens reverse folded stretch not slack, and fixed clamping on the lower fixture.

Operation Procedure

  • According to CNS 1272 to make the sample
  • Turn on the power and check the machine if can be run normally.
  • Turn on the Reverse angle,make the upper grip adjust to carved ring level
  • Install the specimen.
  • Set the test times on counter 
  • Run the test

Notice

  • Specimen clamping with tight not slip for the principle of not holding tight fixture screw teeth or jaw damage
  • Specimens shall be used for clamping with handle, so as not to damage the teeth
  • Startup operation, must be left hand area, can according to rev. Switch on the dashboard, so as not to cause harm
  • Specimen of clamping, the fixture must be in a horizontal position, before clamping can operate the machine otherwise and specimen
  • Test process if there is often happens, should stop the machine immediately to check out, in order to avoid machine damage
  • The parts of the control panel and close switch should be protected from damp and rules
  • Professional operate this machine

Maintenance and Maintain

  • Must turn off the power after the test
  • Keep the machine clearance
  • Motion link must be oiled per month

Recommended Products

Have problems with our Testing Machines?