Bicycle brake road test machine is made according to EN14764 standard. This test machine is suitable for test, brake performance test, design and manufacture in accordance with the specification test requirements, two rollers form a diameter (660~1200mm), meet the specification of the device and the springboard into the load fixing frame at the bottom of the base. From the front and rear wheels according to the specification adjustment to 7~26 km/hr, the maximum can reach 40km/hr, after the specified time, the continuous cycle test, the parts have no damage cracks, according to the specified requirements of the roller brake test friction coefficient, wind speed, lane slope, load hand grip test water spray performance test to determine the product performance quantity.

Hot and cold shock test chamber is a professional equipment used to evaluate the performance of materials and products under conditions of rapid temperature changes.It is widely used in the fields of electronics, automotive industry, aerospace, materials science, etc. By simulating rapid tempe

The xenon test chamber uses a xenon arc lamp as a light source. lt used for the study of weathering and acceleratedaging testing by closely emulating true environmental conditions.Controlled product degradation study (weathering), using varying light spectrum, temperature and moisture. Used toevalua

UV weathering test chamber maintenanceThe maintenance of UV weathering test chamber is very important to ensure that the equipment remains in good working condition for a long time.The following are some basic maintenance measures:1. Environmental control and maintenance: Ensure that the ambie

What is the appropriate water temperature for the lamp tube in the xenon lamp test chamber?The water temperature of the lamp tube in the xenon lamp test chamber should be set according to the test standards and equipment requirements. When conducting IPX5 waterproof test, the water temperature setti

‌How to do the tensile machine peel test？Specific steps of tensile machine peel test‌：1.Preparation phase‌Wipe the peeled steel plate clean with alcohol and wipe it clean with dust-free sandpaper.Tape sampling: Tear off the outer 3-5 layers of tape, use a sampling knife to cut a long strip of s

How to choose a constant temperature and humidity test chamber?A constant temperature and humidity chamber is an environmental test equipment that can control air humidity and temperature. It can simulate the use of products in different environments.Such as high temperature and low humidity,

The flat vulcanizer is also called an automatic tablet press, rubber vulcanizer, small tablet press and hot press molding machine. It is a molding machine that is very suitablefor the mixing and processing of chemical raw materials such as polymers in the rubber and plastic industries, and the

The four functions of the constant temperature and humidity test chamber: The constant temperature and humidity test chamber we have been using is a simple and cost-effective product. Because of its advantages of affordability and mutual benefit, this product is becoming more and more popular. The b

Mechanical testing refers to the physical properties of an object under tensile or compressive loads - pulling, pressing, or untilthe object breaks.Mechanics is divided into tension, compression, bending, shear and fracture. Applying forces to an object at very highspeeds is called "

Before using the universal material testing machine, you need to make the following preparations:1.Check the instrument: Make sure that the power supply and control system of the universal material testing machine are working properly,

1009A How to use Small deformation tester of stainless steelTensile test for metallic materials with force values between 50kn-300kntest speed: 10mm/minIt isa new material testing machine that combined with the electronictechnology and mechanical transmission.it has accurate load speed, range